T-Spin Triple setups

General Tips

• The T tetromino can only fit under the overhang either from sliding or from utilizing the T-Spin Single twist. To use the T-Spin Single twist, make sure the wall opposite the overhang is at least two rows high.

Does not work.

Works

Works

• If a T-Spin Triple is built on top of an empty garbage column, the column will be open after the setup is performed if it lies under the notch or the filled column beside the notch. This can also apply to other columns if their heights are lower than that of the empty cell under the overhang.

• The overhang left over by a T-Spin Triple can be cleared with a twist, namely a T-Spin Single. Slides and line clears also work. The T-Spin Single method is best used if you have a T tetromino ready or coming soon. Delaying the removal of the overhang can cause overstacking which may leave you with an awkward stack, and is time taken away from removing garbage underneath the setup.

T-Spin Single

L-Spin

J Slide

O Line Clear

• Try to build the notch above an empty colomn or cell to set up a T-Spin Double in advance. This combination is referred to as a Triple Double

• You can bailout of the setup with a T-Spin Double to avoid stacking high over an empty column

T-Spin Double

Leaving the 10th column empty

Situational Setups

Overhang

Notch

Garbage Manipulation

TSD Funnel Conversion

TSD Forecast Conversion

Forecasting

Cave TSS to TST

EZ TSS

Openings

Cuts

Place LZ as shown.

Stack and clear the tail of the Z

Stack and create overhang.

LT Variation

SJ Variation

TJ Variation

JT/TL

Jutting TST

TKI's TSD Morph

See also

• Twist - Explanation of twists such as T-Spins
• T-Spin methods - Various methods of creating T-Spins

External Links

• [1]